Electrical Requirements; Re-Routing The Power Cord To The Front Of The Insert; Using The Insert Wiring Kit - Travis Industries 616 Mod-Fyre GSR2 Owner's Manual

Installation (for qualified installers only)

Electrical Requirements

Travis Industries manufactures an "Insert Wiring Kit" for this insert (sku 97200315). This kit allows installers to
wire 120-volt ac power into a fireplace directly to the insert, eliminating the need for an external power cord.

Plug the power cord into a grounded 120-volt outlet (do not remove the grounding pin).

The appliance, when installed, must be electrically grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1.

Do not route the power over the appliance or near any hot or moving components.

Re-Routing the Power Cord to the Front of the Insert

The power cord is shipped attached to the side of the insert. It may be routed to the front where it exits
behind the face but in front of the surround panel. See the directions below for details.
a
Remove the side
access panel.

Using the Insert Wiring Kit

See the instructions included with the Insert wiring kit for attaching the kit to the side of the insert.
a
Remove the side
access panel.
© Travis Industries
c
Disconnect the
molex connection
and remove the
power cord.
a
b
Use pliers to remove
the strain relief.
c
Disconnect the
molex connection
and remove the
power cord.
a
b
Use pliers to remove
the strain relief.
1/10/2022 - 1559
d
Route wires through the
front mounting bracket.
Use pliers to reinstall the
strain relief.
d
Attach the hard wire kit to
insert (see kit instructions for details).
13
d
Reinstall the
access panel
e
Reconnect the
molex connection.
e
Reconnect the Molex connector
and replace the access panel.
616 MF GSR2