Wiring Examples Of Pulse Generators - Mitsubishi AJ65BT-D62 User Manual

4. INSTALLATION AND PRE-OPERATION SETTING PROCEDURE

4.6.3 Wiring examples of pulse generators

POINT
When wiring the AJ65BT-D62 and encoder, separate the power supply and signal lines as shown below.
Incorrect Wiring Example
(1) Pulse generator is open collector output type (24VDC)
REMARK
* ............. Set the pulse input voltage setting pins in the
4 - 11
MELSEC-A
Since the same twisted wire is
used for both the encoder signal
and power supply, the canceling
effect will reduce and electro-
magnetic induction may occur.
position.