Table of Contents
Advertisement
10. PROGRAMMING
Frequency pulse counter command
Frequency time set
Count value reading
Execution of frequency pulse counter
Pulse count stop
Stop of counting
Remote output signal write
10 - 55
MELSEC-A
CH.1 frequency time set
(RWw5): 5000 ms
Write to master station.
CH.1 frequency pulse
count previous value
(RWr2, RWr3) is read.
CH.1 frequency pulse
count current value
(RWr4, RWr5) is read.
CH.1 counter function
selection start command
(RY16) is ON.
CH.1 count enable
(RY14) is OFF.
RY00 to RY7F is written
to Y400 to Y47F.
Advertisement
Table of Contents
