Mitsubishi AJ65BT-D62 User Manual page 111

10. PROGRAMMING
* High-speed counter module status check
* Pulse input mode/function selection register/external output hold-clear settings
*
* Pulse count start
Start of counting
* Current value reading
Current value
reading
* Execution of count disable
Execution of count disable
* Stop of count disable
Stop of count disable
* Pulse count stop
Stop of counting
* When the programmable controller CPU is reset, the pulse input mode/function selection register/external output hold-clear settings are reset.
10 - 33
MELSEC-A
SW head number is set.
"W" is set.
W0 is set.
256 points is set.
Dedicated command
(RRPA)
Head I/O number of
master module
Parameter storage
head device
Data link status is read.
High-speed counter
module data link
is normal.
High-speed counter
module data link
is abnormal.
CH.1 pulse input mode/
function selection register/
hold-clear settings (RWw2)
Initial data processing
completion flag (RY78)
is ON.
Initial data processing
completion flag (RY78)
is OFF.
CH.1 count enable
(RY14) is ON.
CH.1 current value
(RWr0, RWr1) is read.
CH.1 counter function
selection start command
(RY16) is ON.
CH.1 counter function
selection start command
(RY16) is OFF.
CH.1 count enable
(RY14) is OFF.