Sharp HT-X1 Operation Manual page 49

" Audio Signal/Speaker Indicators
Audio signal indicators light up for the corresponding audio source,
and speaker indicators are illuminated according to signals sent to
the speakers.
(1)
Audio signal indicator
(7)
Speaker indicator
(9)
Example:
When 2.1 channel audio signals (L, R, LFE) are received, the audio
signal indicators "L", "R" and "LFE" light up.
The illustration below indicates that 2 channel stereo sound (L and
R) is reproduced.
L, R, LFE: Incoming audio signals
When Dolby Pro Logic
2 channel stereo sound is converted to 5.1 channel surround sound,
and all the speaker indicators " " light up.
" " appears when the speakers are
receiving audio signals.
Audio Signal/Speaker Indicators:
(2) (3)(4) (5) (6)
(8)
(10) (11) (12) (13)
(10)Left Surround Indicator
(11)Subwoofer Indicator
(12)Right Surround Indicator
(13)Right Surround Speaker Indicator
Notes:
! You can switch the audio output when the disc contains sounds
! Sound may not be produced from the subwoofer/amplifier unit
! You cannot change the multi channel mode or stereo mode while
! If sound is unpleasant to listen to, change the multi channel mode
is activated ! Settings for the multi channel mode and stereo mode are
(1)Left Front Speaker Indicator
(2)Left Indicator
(3)Center Indicator
(4)Center Speaker Indicator
(5)Right Indicator
(6)Right Front Speaker Indicator
(7)Low Frequency Effect Indicator
(8)Surround Monaural Signal Indicator
(Lights up when the surround speakers receive monaural sig-
nals.)
(9)Left Surround Speaker Indicator
of multiple audio formats (Dolby Digital, DTS, etc.). See page 34.
depending on the disc.
listening to the radio.
or stereo mode.
retained by input (DVD, AUX DIGITAL and AUX ANALOG).
HT-X1
49