Sharp UX-P100 Operation Manual page 74

Messages and Signals
LCR DOWNLOADING
LINE ERROR
MEMORY IS FULL/
SEE MANUAL
(alternating messages)
MEMORY PRINTING
NO DATA
NO SERVICE
OFF HOOK
ON HOOK DIAL
OVER HEAT
READY TO SEND
72
The fax machine has called OpenLCR and is
receiving carrier rate data. This message only
appears if you have registered with OpenLCR.
Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error on page 67.
The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been received
to memory because printing is not possible (an
additional message will indicate the problem), resolve
the problem so that printing can continue (see
Substitute Reception to Memory on page 51). If you
are attempting to transmit from memory, see If the
memory becomes full on page 45. If you are copying,
see If MEMORY IS FULL appears on page 52.
The fax is preparing to or printing out a document
from memory.
This appears if you attempt to search for an auto-dial
number when none have been stored.
This appears if you haven't registered with OpenLCR
and press the FUNCTION key and 7.
This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.
The SPEAKER key has been pressed and the fax
machine is waiting for you to dial.
The print head has overheated. Operation can be
continued after it cools. If overheating frequently
occurs, try changing the print contrast setting to
LIGHT (see page 15).
A document has been loaded and the fax machine is
waiting for you to begin faxing or copying.