Sharp UX-P100 Operation Manual page 33

Note: The following settings are not required as of the printing
of this manual. OpenLCR will inform you through its Web site
(www.OpenLCR.com) if the settings become necessary in the future.
Selecting a long or short call
Before you make a long distance or international phone/fax call, select
whether the call will be a long call or a short call.
♦
Your fax needs to know whether the call will be long or short to route it for
the best rate.
1
OpenLCR
Press ,
•
Note: If the display shows TABLE NOT
EXIST, you must first download the rate
data.
2
Press to select the SHORT TIME setting, or
1
TIME setting.
•
The initial SHORT TIME setting is 2 minutes, and the initial LONG TIME
setting is 4 minutes. If desired, you can change these settings as explained
on the following page.
•
The short/long time selection will remain in effect for all calls until you
change it.
Changing the SHORT TIME and LONG TIME settings
The initial SHORT TIME setting is 2 minutes, and the initial LONG TIME
setting is 4 minutes. If the typical durations of your short and long calls are
different, you should change the time settings to ensure that OpenLCR routes
your calls for the best rate.
♦
For example, if your fax transmissions normally last about 3 minutes and
your phone calls last about 5 minutes, set 03 for the SHORT TIME and 05
for the LONG TIME. Before sending a fax, select the SHORT TIME setting
(03MIN) in the procedure on the preceding page. Before making a phone
call, select the LONG TIME setting (05MIN).
FUNCTION
.
Setting Up and Using OpenLCR
Display:
LCR TABLE SELECT
to select the LONG
2
31