Adjusting The Headlights; Using The Horn - Toro Groundsmaster 4500-D Installation Instructions Manual

Note:
The brake lights will come on when the
machine is slowing down from the hydrostatic-dynamic
braking or when the brakes pedals are pressed.
1. Turn the key switch.
2. Rotate the light switch
to the following positions:
•
Low beam
•
O position
FF
•
Low beam
Using the Turn Signal
•
Move the turn signal switch
signal a right turn.
•
Move the switch down to signal a left turn.
•
Move the switch to the middle position to shut off
the turn signals.

Using the Horn

Press the horn button (Figure
Using the Hazard Lights
The hazard lights are the flashing lights that warn the
machine is stationary or moving slow.
Figure 47
1. Hazard switch
•
Press the top of the switch
hazard lights.
Note:
The hazard switch illuminates when
running the hazard lights.
•
Press the bottom of the switch to shut off the
hazard lights.
(Figure 45 and Figure 46)
(Figure 45) up to
45) to sound the horn.
g351460
(Figure 47) to run the

Adjusting the Headlights

1. Loosen the mounting locknuts and capscrews to
adjust the lights
1. Capscrew (horizontal light
adjustment)
2. Locknut (horizontal light
adjustment)
2. Adjust the lights per local standards.
3. Tighten the locknuts and capscrews
24
(Figure 48).
Figure 48
3. Locknut and capscrew
(vertical light adjustment)
(Figure
g351458
48).