Toro Groundsmaster 4500-D Installation Instructions Manual page 8

Note:
Ensure that the turn-signal lens on the
headlight is positioned toward the outside of the
traction unit.
Figure 7
Right headlight assembly shown
1. Headlight
2. Pivot bolt with locknut
3. Mounting bolt
3. Tighten the locknut to firmly hold the headlight
assembly to the headlight bracket.
Note:
Do not overtighten the locknut.
g371180
4. Pivot bracket
5. Washer
6. Locknut (M12)
Installing the Headlight Bracket to
a Cab Model
1. Install a bent-plate bracket onto each of the
upper corners of the lower front panel of the cab
with the existing screws as shown in
1. Bolt (5/16 x 1-5/8 inches)
2. Washer
3. Bent-plate bracket
4. Spacer
2. Loosely install a rubber hanger to each
bent-plate bracket with a bolt (5/16 x 1-5/8 inch),
2 washers (3/8 inch), a spacer, and a flange nut
(5/16 inch) as shown in
3. Loosely install the left and right headlight
brackets to the front of the roller-support tube
with 6 bolts (3/8 x 2-1/2 inches) and flange nuts
(3/8 inch). Position the brackets as shown in
Figure 9.
Note:
Ensure that the holes in the bent-plate
brackets align with the holes in the rubber
hangers.
8
Figure
Figure 8
5. Rubber hanger
6. Flange nut (5/16 inch)
7. Screw (existing)
Figure 8.
8.
g034337