Using The Belt Clip; Using A Headset; Handset Setup Menu; Auto Talk - Radio Shack 43-3577 User Manual

Using the Belt Clip

You can use a belt clip to hang the handset on your belt
for greater convenience when using a headset or when
expecting a call.
To attach the belt clip:
Line up and insert the belt clip into the holes on each side
of the handset. Press down until it clicks.
To remove the belt clip:
Pull either side of the belt clip to release the tabs from
the holes.

Using a Headset

You can connect an optional headset with a
Open the rubber cover on the side of the handset. Then insert the
headset's plug into the jack.
When you finish using the headset, disconnect it from the handset
and close the rubber cover to protect the jack.
n
Note: If you place the handset on the base to recharge it while
the headset is connected, be sure the handset seats properly.

Handset Setup Menu

Press MENU when phone is not in use to enter the handset setup
menu.
Press RING/VOL +/– to select menu options. An arrow appears in front of the
selected option.

Auto Talk

Auto Talk allows you to answer the phone without pressing TALK. When Auto
Talk is On, Removing the handset from the base answers the call.
1. Press MENU.
2. Select
Auto Talk
3. Press SELECT to toggle between
4. Press MENU and return handset to the base.
.
On
14
/ inch (2.5 mm) plug.
3
32
and .
Off
g
Auto Talk : On
CIDCW : On
Area Code: