Radio Shack 43-3576 Quick Start Manual

Big Button Cordless Phone
with Headset Jack
43-3576
Quick Start Guide
for installing, setting up and using your new product
Install and Charge
the Handset Battery
1. Press down and
slide off the battery
cover.
Battery
Pack
2. Remove the battery
pack and plug the
Cover
battery pack's
connector into the
socket in the battery
compartment (fits
only one way). Replace
the battery pack and the cover.
3. Insert the AC adapter's barrel plug into
the base's jack on the back of
DC IN 9V
the base, and
route the excess
Base
cord through the
strain relief slot.
Plug the adapter
into a wall outlet.
4. Place the
handset on the
base and charge
DC IN 9V
continuously for
Jack
15-20 hours
Strain Relief Slot
before using the phone.
Connector
Socket

Using Your Phone

Connect to a Phone Line
When the handset battery pack is fully charged, plug
the telephone cord into the
TEL LINE
of the base. Plug the other end into a telephone wall
jack.
Wall
Jack
Note: The illustration shows the wall-mount bracket
attached. See page 9 of your Owner's Manual for
how to attach and use the bracket.
Your phone is set for tone dialing. If your phone uses
pulse service, please see "Choosing the Dialing
Mode" on page 12 in your Owner's Manual.
Making Calls
Pick up the handset and press TALK. Listen for the
dial tone, and then dial the number. Or, dial the
number and then press TALK.
Answering Calls
If Auto Talk is on, just pick up the handset from the
base. If Auto Talk is off, pick up the handset and
press TALK. For more information, see "Setting
Menu Options" on page 16 of your Owner's Manual.
If the handset is off the base, press TALK, or, with
Auto Talk on, press any number,
©2004 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are
trademarks used by RadioShack Corporation.
jack on the back
TEL LINE
Jack
Wall Bracket
∗
f g
/TONE/ or #/ .
43-3576
Printed in China
04A04
UCZZ69434BZ