Radio Shack 43-3575 Quick Start Manual

43-3575
900 MHz cordless telephone
with caller id/call waiting id
Quick Start Guide
Please read this user's guide before
installing, setting up and using your new product
www.radioshack.com
Note: Actual product may vary from the images found in this
document.
©2005. RadioShack Corporation.
43-3575
All rights reserved. RadioShack and
12A05
RadioShack.com are trademarks UCZZ01441BZ
used by RadioShack Corporation.
Printed in China
Your phone's handset comes with a rechargeable nickel metal
hydride (Ni-MH) battery pack already installed.
 Before charging the battery for the first time, push the pin for activation,
located on the bottom of the handset (see label with instructions).
 Once activated, remove the label, and then place the handset in the
base unit to charge.
• Do not plug your phone into the phone line while charging.
Notes
• Charge your phone for 15-20 hours without interruption.
replacing your battery pack
 Unscrew your battery compartment cover and remove the old battery
pack.
 Plug the replacement battery connectors (red and black wires) into
the small, black jack inside the battery compartment. They fit only one
way.
 Replace your battery cover. To ensure it is securely connected, insert
the bottom first.
connecting your phone
 Plug one end of the supplied long
modular cord into the TEL LINE jack.
 Insert the supplied AC adapter's
barrel plug into the DC IN 9V jack on
the bottom of the base and route the
adapter's cord through the strain relief
slot on the base.
 Plug the other end of the modular cord
into a modular phone line jack.
 Plug the adapter into a standard AC
outlet.
Note: Refer to page 8-9 of your User's
Note
Guide for wall mounting instructions.
activating and charging your battery pack


using your cordless phone
making and receiving calls
To make a call:
 Pick up the handset.
 Press TALK/ FLASH.
 Listen for the dial tone and dial the
number.
OR
 Pick up the handset and dial the number.
 Then press TALK/FLASH.
To receive a call:
If Auto Talk is on, just pick up the handset; and, if Auto Talk is off,
pick up the handset and press TALK/FLASH.
If the handset is off the base and Auto Talk is on, press
TALK/FLASH, any number, /TONE/< or #/>. Or, if Auto Talk is off,
Note
press TALK/FLASH. Refer to page 16 of your User's Guide for more
information on the Auto Talk feature.



TALK/FLASH