Pens With Erasers - Smart Technologies SMART kapp iQ Pro 55 Administrator's Manual

CHAPTER 1
WELCOME
Indicator light Status
Off Not receiving power
Solid amber DPMS (power
management) mode
Slowly flashing Standby mode
amber
Flashing amber No USB connection from
the connected computer
Slowly flashing SMART Board service not
white running on the connected
computer

Pens with erasers

The interactive flat panel comes with two pens with erasers attached.
The interactive flat panel's bottom frame includes magnetic holders for the pens. Removing a pen
from the holders activates it, and you can use it to draw or erase digital ink.
CAUTION
When you return the pen to the magnetic holder, make sure it's centered in its holder to keep it
from falling and being damaged.
4
This only applies when a computer is connected to the interactive flat panel's computer connectors.
6 smarttech.com/kb/171000
Troubleshooting
Confirm the interactive flat panel's power cable is
connected to the power outlet (see page 19).
Flick the power switch to the ON (I) position (see
page 24).
Press the Standby button
Connect an input source.
Press the Standby button
If presence detection is enabled, move in range of
the presence detection sensor. See Proximity (
support.smarttech.com/docs/hardware/kapp/kapp-
iq-pro/en/installing-and-maintaining/using-the-osd-
menu/default.cshtml).
If wake-to-touch is enabled, touch the screen. See
Wake to Touch (
support.smarttech.com/docs/hardware/kapp/kapp-
iq-pro/en/installing-and-maintaining/using-the-osd-
menu/default.cshtml).
Verify the connections to the room computer (see
page 20).
Switch to the room computer's input source (see
page 25).
Ensure that SMART Product Drivers is installed and
that the SMART Board service is running.
to exit DPMS mode.
to exit Standby mode.
4