Preparing The Pens - Smart Technologies SMART Board V280 Installation And User Manual

To prepare the pens
18 | I N S T A L L IN G A N D S E C U R I N G Y O U R S M A R T B O A R D V 28 0 I NT E R A C T I V E
W H I T E B O A R D

Preparing the Pens

Refer to the following procedure to prepare the included interactive whiteboard pens
for use.
1. Pull back the battery cover of each pen to open
the battery compartment, and then insert
an AAA battery, as illustrated.
2. Press the tip switch on the nib of each pen
with your finger to check that the pen is working
properly. The LED light beside each battery
compartment illuminates green. Place the pens
on the pen tray.
NOTES
– A green LED light indicates that the
pen is operating properly. A red LED
light indicates that less than one hour
of battery operating time remains.
– If the pen's LED light doesn't illuminate when you press the tip switch
on the nib, see page 60.
After you install your interactive whiteboard, connect your digital projector to your
computer by following the manufacturer's instructions included with your projector.