Power Tool Use And Care; Service; Appliance-Specific Safety Instructions - Parkside 3 EN 1 PMFS 200 C3 Translation Of The Original Instructions

4 . Power tool use and care

a) Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at
the rate for which it was designed .
b) Do not use the power tool if the switch does
not turn it on and off. Any power tool that
cannot be controlled with the switch is
dangerous and must be repaired .
c) Disconnect the plug from the power source
and/or remove the battery pack, if detach-
able, from the power tool before making any
adjustments, changing accessories, or storing
power tools. Such preventive safety measures
reduce the risk of starting the power tool acci-
dentally .
d) Store idle power tools out of the reach of
children, and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users .
e) Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation. If
damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools .
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control .
g) Use the power tool, accessories and tool bits,
etc., in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation .
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for
safe handling and control of the tool in unex-
pected situations .
PMFS 200 C3

5 . Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained .
b) Always arrange for the replacement of the
plug or the power cord to be carried out by
the manufacturer of the appliance or by his
approved customer services. This will ensure
that the safety of the power tool is maintained .

Appliance-specific safety instructions

■ Secure the workpiece . A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand .
■ Do not rest your hands next to or in front of the
appliance and the area being worked as there
is a risk of injury if you slip .
■ In the event of danger, remove the mains plug
from the socket immediately .
■ Always route the power cable towards the rear,
away from the appliance .
■ RISK OF FIRE DUE TO FLYING SPARKS! If
you sand metal, sparks will be produced . There-
fore, make sure that nobody is at risk and that
no combustible materials are located in the
immediate vicinity of where you are working .
■
Hold the power tool by the insulated gripping
surfaces, as the grinding surface could hit its
own cable. Damage to a live wire may make
exposed metal parts of the power tool live and
could give the operator an electric shock .
WARNING! TOXIC VAPOURS!
► Working with the tool can produce harmful/
toxic dusts that represent a health hazard for
the person operating the appliance and for
any other people in the area .
GB │ IE │ 5 ■