Dust Box; Reducer; Use; Switching On And Off - Parkside 3 EN 1 PMFS 200 C3 Translation Of The Original Instructions

Dust box

Connecting
♦ Slide the dust box
sure that the symbol on the dust box
aligned with the ▸ symbol on the appliance .
Turn the dust box
(see detailed illustration fig . D on the fold-out
page) .
Removal
♦ Turn the symbol on the dust box
▸ symbol on the appliance (see detailed illustra-
tion fig . D on the fold-out page) . Pull the dust
box off the appliance .
NOTE
► To achieve optimum dust extraction, the dust
box should be emptied regularly .
♦ To do this, remove the dust box
appliance as described above . To do this,
open the dust box
button and pulling off the rear part . Now
remove the dust bag
thoroughly by tapping it out .
■ 8 │ GB │ IE
onto the appliance . Make
is
to the symbol to lock it
to the
off the
by pressing on the release
. Clean the dust bag

Reducer

Connecting
♦ Push the reducer
♦ Push the hose of a suitable of vacuum cleaning
appliance (e .g . a workshop vacuum cleaner)
onto the reducer
Removal
♦ Pull the hose of the vacuum cleaner off the
reducer .
♦ Remove the reducer

Use

CAUTION!
► Ensure that the appliance is switched off
before connecting it to the mains .
NOTE
► Always switch the multi-sander on before
applying it to the material, then move it over
the workpiece .

Switching on and off

Switching the appliance on
♦ Move the ON/OFF switch
tion .
Switching the appliance off
♦ Move the ON/OFF switch

Setting the oscillating speed

You can set the desired oscillating speed using the
speed selector as required . The required speed
depends on the material being processed and can
be determined through practical tests .
into the adapter fitting
.
.
to the "I" posi-
to the "0" position .
PMFS 200 C3
.