Chapter 1
Installing the Application Gateway
Installing the Application Gateway
Installing the Application Gateway
1
2
3
4
12
Application Gateway Hardware Installation Guide
When installing the Application Gateway, refer to the following
illustration for port locations.
To install the Application Gateway:
Install the Application Gateway in a rack (if rack-mounted).
Connect the power cord to the AC power receptacle.
Connect the 10/100 RJ45 NIC connectors located on the Application
Gateway back panel as follows.
If the Application Gateway can access the connected device (router,
•
application server, etc.) from the same subnet as it receives client
requests, use one network cable. Connect Application Gateway
interface port 0 (LAN1) to your network. This is the typical
configuration.
If the Application Gateway will straddle two networks, use two
•
network cables:
Connect Application Gateway Interface 0 (LAN1) to the client-side
–
network.
Connect Application Gateway Interface 1 (LAN2) to the
–
server-side network, directly or indirectly.
Connect the null-modem cable to the 9-pin serial port on the Application
Gateway and connect the cable to a computer that is capable of running
terminal emulation software.