Table of Contents
Advertisement
A b o u t t h e B a t t e r y S t a t u s L E D s
The charger is mounted on the Power Panel. The MWS Battery Status LEDs
are located on the top-left side of the Power Panel. To use the Battery
Status LEDs, the MWS must be on. The MWS Battery Status LEDs provide
the most accurate indication of battery status.
Store the MWS in a dry area not subject to prolonged sub-zero
temperatures.
The "intelligent" battery charger monitors the batteries condition and
does not overcharge the batteries. It is recommended to leave the
battery charger plugged in and charging when the MWS is not in use.
Battery life is extended by frequent charging.
The Green Full Charge LED on the Power Panel blinks when the battery
is finished (or near finished) charging. Leaving the charger connected to
the battery and plugged in (MWS power off) prevents the battery from
self-discharging.
12 Volt switch levels = +/- 0.15V; 24 Volt switch levels = +/- 0.25V
A b o u t t h e B a t t e r y C h a r g e r
When charging the batteries with the MWS powered Off, use the charge
indicator on the left side of the charger. The 12VDC and 24VDC chargers
display battery status differently.
The 12VDC charger's bi-color LED displays the following:
Red
Flashing Green
(Slow)
Green
Flashing Green
(Fast)
Charging process has started (fan on).
Charging is in process, but not fully charged.
Batteries are fully charged (fan off), and the charger
switches between pulse-charge and charge.
The charger is not properly connected to the batteries.
Bi-Color
LED
Charging the Batteries 3-3
Advertisement
Table of Contents
