Defining Text Fields; About Text Fields - Paxar Monarch DOS-based Pathfinder Ultra System 6035 User Manual

D E F I N I N G T E X T F I E L D S
Create a separate definition for each text field. There are two types of text
fields:
Simple
Combo
(combination)
NOTE: If text falls on two lines, each line of text requires a separate
definition.
All samples shown in this chapter are created using 2.0-inch long by 2.0-inch
wide supplies.
A b o u t T e x t F i e l d s
Read the following information to become familiar with the prompts for text
fields. Valid ranges for the prompts are listed as well as information about
using text fields.
Format Name
Format Number
Format
Description
Supply Length
Contains data entered specifically for that field.
Contains data pulled from up to 10 other fields.
Depending on your printer's configuration, enter a name for
the format. For more information about your printer's
configuration, see Chapter 3, "Configuring the Printer." The
maximum number of characters for the format name is 16.
Reserved for future use. (Depending on your printer's
configuration, enter a number for the format. The format
number range is 1 – 99.)
Reserved for future use. (Depending on your printer's
configuration, enter a description for the format.)
The length of your loaded supply. Measure from the top of
one black mark to the top of the next black mark. The
standard supply lengths are: 55, 78, 110, 150, 200, 300, or
400 inches.
5

Defining Text Fields 5-1