AGFA Drystar AXYS Reference Manual page 44

44 | Drystar AXYS | Advanced Operation (key-operator mode)
• If you want to attribute the default profile, select 'Profile default' and
• If you want to add a custom profile, select 'Select other' and press the
• If the parameter for the selected modality has been set via a remote
4. The printer will continue with the 'Select for Modality' screen, allowing
you to change the Look-up table, the Interpolation and the maximum
density (Dmax) values manually.
<Modality name>
3 Dmax
5. In the 'Select for Modality' screen, press the Down key twice, followed by
the Confirm key to select 'Dmax'.
The 'Dmax (maximum density)' screen is displayed:
<Modality name> <Modality name>
1*Linear
2.80
2 Kanamori
2.85
... 3 Kanamorilike (100)
*3.10
3.15
...
3.40
All maximum densities are selectable starting from 2.80 to 3.40 in steps of
0.05 units.
The activated setting is marked with a '*'.
2853E EN 20210520 0952
press the Confirm key.
The printer will be loaded with these settings and return to the 'Image
quality' main menu (see step 1).
Confirm key. Proceed with step 4.
computer, you will not be able to change the image quality information
for this modality via the local keypad. In this case the following screen
will appear:
<Modalityname>
Note: In case the image quality parameters need to be
changed for this modality, please use the DICOM
Configuration tool in the Key-operator mode via a remote
connection. Alternatively, you can also remove this modality
and add a new modality with the same name. For this new
modality new parameters can be assigned via the local
keypad.
Note: The maximum density will be limited to the maximum
density of the media.
<Modality name>