AGFA Drystar AXYS Reference Manual page 42

42 | Drystar AXYS | Advanced Operation (key-operator mode)
2. Press the Up/Down key, followed by the Confirm key to select the modality
for which you want to change the Image quality settings.
The 'Image quality' screen for the selected modality is displayed:
3. Do one of the following:
• If you want to attribute the default profile, select 'Profile default' and
• If you want to add a custom profile, select 'Select other' and press the
• If the parameter for the selected modality has been set via a remote
4. The printer will continue with the 'Select for Modality' screen, allowing
you to change the Look-up table, the Interpolation and the maximum
density (Dmax) values manually.
<Modality name>
3 Dmax
5. In the 'Select for Modality' screen, press the Down key, followed by the
Confirm key to select 'Interpolation'.
The 'Interpolation' screen is displayed:
<Modality name>
<Modality name>
1*Replication
1*Linear
2 Linear
2 Kanamori
3 Cubic Hi-res
3 Kanamorilike (100)
4 CubicBel
5 None
6. Press the up/down key to select the desired interpolation setting for this
modality.
2853E EN 20210520 0952
press the Confirm key.
The printer will be loaded with these settings and return to the 'Image
quality' main menu (see step 1).
Confirm key. Proceed with step 4.
computer, you will not be able to change the image quality information
for this modality via the local keypad. In this case the following screen
will appear:
<Modalityname>
Note: In case the image quality parameters need to be
changed for this modality, please use the DICOM
Configuration tool in the Key-operator mode via a remote
connection. Alternatively, you can also remove this modality
and add a new modality with the same name. For this new
modality new parameters can be assigned via the local
keypad.