Getting Ready To Sew Connecting The Power Supply - Janome Continental M17 Instruction Book

q
e
w
GETTING READY TO SEW
Connecting the Power Supply
z First make sure the power switch q is off.
x Insert the machine plug w of the power supply cable
z
c Insert the power supply plug r into the wall outlet t,
c
x
NOTE:
• Make sure to use the power supply cable that came
• If you turn off the power switch, wait for 5 seconds
t
r
• While in operation, always keep your eyes on the
c
• Always turn off the power switch and unplug the
•
Operating Instructions:
The symbol "O" on the switch indicates the "off" position
of the switch.
Foot controller Model 21390 is for use with sewing
machine Continental M17.
For the U.S.A. and Canada only
Polarized plug (one blade wider than the other):
To reduce the risk of electric shock, this plug is intended
to fit in a po ari ed out et on one a
u
contact a ua ified e ectrician to insta the proper out et
Do not modify the plug in any way.
13
into the machine socket e.
and turn the power switch q on.
q Power switch
w Machine plug
e Machine socket
r Power supply plug
t Wall outlet
with the machine.
before turning it on again.
WARNING:
sewing area, and do not touch any moving parts
such as the thread take-up lever, handwheel or
needle.
machine from the power supply:
- when leaving the machine unattended.
- when cleaning the machine.
o not p ace an o jects on the oot contro
in the out et re erse the p ug
it does not fit
it sti does not fit