Janome Continental M17 Instruction Book page 65

z
q
w
e
x
r
B1 Sensor (Square) Buttonhole
The size of a buttonhole is automatically set by placing a
button in the rear of automatic buttonhole foot R.
The button holder of the foot takes a button size of 1 cm
When selecting the buttonholes, the right touch screen
advises you to lower the buttonhole lever.
NOTE:
• It is sometimes necessary to change buttonhole
si e to match certain hea
threads.
• Make a test buttonhole on an extra piece of the
fabric to check your settings.
• The preset width of the buttonhole is suited for
ordinary buttons.
• App an inter acing to stretch or fine a rics
Sewing
z Pull the button holder to the back, and place the
button in it. Push it together tightly on the button.
NOTE:
•
the buttonhole length if necessary by turning the
adjusting scre on the uttonho e oot
• To increase the uttonho e ength turn the adjusting
screw to move the marker toward "L".
• To decrease the uttonho e ength turn the adjusting
screw to move the marker toward "S".
w Adjusting scre
e Marker
x Press the needle up/down button to raise the needle.
Press the lockout key.
Raise the presser foot and attach automatic
buttonhole foot R snapping the pin into the groove of
the foot holder.
You may lift the presser foot lifter to the extra lifted
position when placing the automatic buttonhole foot
under the foot holder.
t
Press the lockout key to unlock the machine.
63
to cm in diameter
q Button holder
hec the ength o the test uttonho e and adjust
r Groove
t Pin
or specific a rics and