BMW M4 COUPE Owner's Handbook Manual page 115

General
Two kinds of on-board computer are available
on the Control Display:
▷ "On-board computer": average values
such as the consumption are displayed.
The values can be reset individually.
▷ "Trip computer": values provide an over‐
view of a particular route, and can be reset
as often as required.
Calling up the on-board computer or
trip computer
Via iDrive:
1. "My Vehicle"
2. "Driving information"
3. "On-board computer" or "Trip computer"
Resetting the on-board computer
Via iDrive:
1. "My Vehicle"
2. "Driving information"
3. "On-board computer"
4. "Consumption" or "Speed"
5. "OK"
Resetting the Trip computer
Via iDrive:
1. "My Vehicle"
2. "Driving information"
3. "Trip computer"
4. If necessary, tilt the Controller to the left.
▷ "Reset": all values are reset.
▷ "Reset automatically": all values
are reset if the vehicle is at a standstill
for approximately 4 hours.
Online Edition for Part no. 01402981699 - VI/17
Displays
Sport displays
General
On the Control Display the current values for
performance and torque are shown if the vehi‐
cle is appropriately equipped.
Showing sport displays
Via iDrive:
1. "My Vehicle"
2. "Technology in action"
3. "Sport displays"
Speed warning
Principle
A speed limit can be set which triggers a warn‐
ing when it is reached.
General
The warning is repeated if the vehicle speed
exceeds the set speed limit again, after it has
dropped below 5 km/h/3 mph.
Displaying, setting or altering the
speed warning
Via iDrive:
1. "My Vehicle"
2. "Vehicle settings"
3. "Speed warning"
4. "Warning at:"
5. Turn the Controller until the desired speed
is displayed.
6. Press the Controller.
Controls
115