Overview of the
consumption values
when regenerating the
softening system
Here you will find an overview of the
maximum additional runtime and
consumption values when regenerating
the softening system.
Regenerating the softening
system after x washes
Additional running time in minutes
More water consumption in litres
More power consumption in kWh
The stated consumption values are
laboratory measured values which
are determined according to the
currently valid standard and on the
basis of the Eco 50° program and the
factory-set water hardness value of 13
- 16 °dH.
Rinse System
Crockery and glasses can be washed
without a problem using the rinse
system and rinse aid.
rinse aid
For optimal drying results it is best
to use the rinse aid.
Only use rinse aid for household
dishwashers.
Filling rinse aid
If the rinse aid refill indicator lights up,
add rinse aid. Only use rinse aid
share for household
The lip on the deck
1.
rinse aid
know and lift
6
6
5
0.05
and dishwashers.
ell of it
servo press
†
Top up the rinse aid up to the max
2.
mark.
If rinse aid has spilled over, it must
3.
be removed from the rinse aid
container.
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
Close the lid of the rinse aid
4.
reservoir.
aThe lid audibly clicks into place.
Set the rinse aid amount
If streaks or water spots remain on the
dishes, adjust the amount of rinse aid.
Press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
Rinse SystemNL
2
1
max
Busy-
29