Kenwood TS-870S Instruction Manual page 23

S
PWR
SWR
COMP
HF TRANSCEIVER
!5 MENU
Lights while Menu mode is being accessed. Flashes
when the Menu has been temporarily reset {page 24}.
!6 A/B
"A" lights while Menu A is being accessed. "B" lights
while Menu B is being accessed {page 24}.
!7 SPLIT
Lights while a different transmit and receive frequency
are selected for split frequency {page 42}.
!8 RIT
Lights while the Receive Incremental Tuning function is
ON {page 44}.
!9 TONE
In FM mode, lights while the subaudible Tone function is
ON while operating split frequency {page 39}.
@0 XIT
Lights while the Transmit Incremental Tuning function is
ON {page 45}.
@1 NB
Lights while the Noise Blanker is ON {page 53}.
@2 WIDTH
In all modes except SSB and AM, lights after the
LO/WIDTH control is adjusted. Indicates that the
number reported below it on the Display is the receive
bandwidth {page 52}.
@3 CTRL
Lights while data is being exchanged between a
computer and the transceiver during computer control
{page 50} or between two transceivers during Quick
Data Transfer {page 65}.
7 9
VOX
M.CH
50
FILTER
3
AUTO
TS-870
@5 @6 @7 @ 8 @9 # 0 # 1
FULL SEMI AIP AGC AUTO PROC MONI
LSB USB CW R FSK FM AM
ON AIR AT TUNE
@4 SHIFT
In CW, lights after the HI/SHIFT control is adjusted.
Indicates that the number reported below it on the
Display is the shift of the receive pass band {page 51}.
@5
Shows the selected memory channel {page 55},
Menu No.{page 24}, and Automatic Mode boundary
numbers {page 48}. The dot lights while a memory
channel is locked out. This indicates that the channel
will be skipped during Memory Scan {page 62}.
@6 AUTO
Lights while Automatic Mode is ON {page 48}.
Automatic Mode automatically controls the operating
mode according to instructions that you provide.
@7
Shows the operating frequency to a resolution of 10 Hz
{page 20}. Also shows the Menu selections while in
Menu mode {page 24}.
@8 LSB
Lights while in the Lower Sideband operating mode
{page 20}.
@9 USB
Lights while in the Upper Sideband operating mode
{page 20}.
#0 CW
Lights while in the CW operating mode {page 20}.
#1 R
Lights while the Reverse function is used with FSK or
CW. The Reverse function reverses the mark and
space frequency relationship for FSK {page 20}, and
uses the opposite sideband for CW {page 20}.
3 GETTING ACQUAINTED
!5 !7 !9 @1 @3
!6
!8 @0 @2 @4
MENU SPLIT TONE NB CTRL
A B RIT XIT WIDTH SHIFT
M. SCR PRG SCAN F. LOCK FINE MHz
17