Chapter 14 Installing Options; Removing The Case; Top Case; Bottom Case - Kenwood TS-870S Instruction Manual

Intelligent digital enhanced communications system
Hide thumbs Also See for TS-870S:
Table of Contents

Advertisement

INSTALLING OPTIONS

REMOVING THE CASE

TOP CASE

1 Remove the screws (10 screws).
2 Lift off the top case.

BOTTOM CASE

1 Remove the screws (12 screws).
2 Lift off the bottom case.
DRU-3 DIGITAL RECORDING UNIT
Switch OFF the power and unplug the DC power cable
CAUTION:
before beginning installation.
Refer to "INTERNAL ADJUSTMENTS" {page 70} for
Note:
information on adjusting the recording level.
EQUIPMENT REQUIRED:
Large Phillips screwdriver
Small Phillips screwdriver
1 Remove the bottom case (12 screws).
2 Remove Cover A (see diagram) (7 screws).
3 Locate the CN5 connector in the transceiver.
Remove the paper backing from one side of the
supplied cushion, then install the cushion. Remove
the paper backing from the other side of the installed
cushion, then plug the DRU-3 connector (CN901)
into CN5.
w
CN901
DRU-3
CN5
4 Re-install Cover A (7 screws).
5 Replace the bottom case and re-install its screws
(12 screws).
VS-2 VOICE SYNTHESIZER UNIT
Switch OFF the power and unplug the DC power cable
CAUTION:
before beginning installation.
EQUIPMENT REQUIRED:
Large Phillips screwdriver
Small Phillips screwdriver
1 Confirm that the small switch on the VS-2 unit is in
the "ENGLISH" position.
2 Remove the bottom case (12 screws).
3 Remove Cover A (7 screws).
VS-2
ENGLISH
CN6
4 Locate the CN6 cable in the transceiver, and plug
this cable into the VS-2 unit.
Threaded
post
CN6
Cover A
q
CN5
Cover A
Threaded
VS-2
post
75

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ts-870

Table of Contents