Initial Setup
Point Configuration
Note: At initial setup, all points except Point 1 are
disabled by default and are inactive on the Point
Configuration screen. Configuration of Point 1 is
required for device initialization.
1. On the Point Configuration screen, select Point 1.
2. Select Next.
3. On the Point Configuration: Point # screen, select
Enable.
4. Select the Name field, and use the alphanumeric
keypad pop-up to assign a name with up to
18 characters. Select
The entire 18 characters will only show on the Point
Detail screen. Only 10 characters will show on the
Point Configuration screen.
5. Select Save.
6. Repeat
Step 1
through
points have been configured.
7. On the Point Configuration screen, select Next.
18
to accept the value.
Step 5
until all of the necessary
8. The Initial Setup screen shows a check mark beside
the Point Configuration step to indicate that it is
complete. Select Continue to go to the gas
configuration setup.
RMWH-SVX001C-EN