Peg-Perego DUETTE Instructions For Use Manual page 12

EN_English
WARNING!
_ IMPORTANT: Keep these instructions for future
reference. Read and keep them for safety use.
The child's safety could be at risk if these
instructions are not followed.
_ This item was designed for the transport of 2 children
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ This product is approved for children from birth up to
a weight of 15 kg in the seat.
_ For new born babies is recommended to use the
backrest in the most reclined position.
_ This product was designed for use in combination
with Peg Perego Ganciomatic products : Duette Piroet
+ Seggiolino Duette/Triplette Pop-Up is approved
for children from birth up to 15 kg of weight ; Duette
Piroet + Primo Viaggio (0+ group) is approved for
children from birth up to 13 kg of weight / Duette
Piroet + Navetta Pop-Up is approved for children from
birth up to 9 kg of weight.
_ When used in combination with pram body : this
product is suitable for a child who cannot sit up by
itself, roll over and a cannot push itself up on it's
hands and knees. Maximum weight of the child : 9 kg.
Don't apply and don't use any different mattress of
that specified by the Manufacturer in the Instruction
Manual of pram body.
Any carrying handle (if present) shall be left out of the
pram body during use.
_ When used in combination with car seat (0+ group ),
this vehicle does not replace a cot or a bed.
Should your child need to sleep, then it should be
placed in a suitable pram body, cot or bed.
_ WARNING! Ensure that all the locking devices are
engaged before use.
Check that the Peg Perego Ganciomatic products are
correctly fixed to the item.
_ WARNING! Check that the pram body or seat unit or
car seat attachment devices are correctly engaged
before use.
_ WARNING! Always use the restraint system. Always
use the harness crotch strap in combination with the
waist strap.
_ WARNING! To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_ WARNING! This product is not a toy. Do not let your
child play with this product.
_ WARNING! The assembly and preparation of the
product must be carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING! Never leave your child unattended.
_ Always apply the brake when stationary.
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest ... ).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer's instructions regards the maximum
loads transportable.
_ The front bar (if present) is not designed to support
the child's weight. It is not designed to keep the child
in the seat and does not substitute for the waist belt.
_ Do not load the baskets over 5Kg. Do not put weight
in the cup holder (if present) in excess of those
indicated on the cup holders themselves and never
hot drinks. Do not put loads of more than 0.2 Kg in
the hood pockets (if present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or recommended by
the manufacturer/distributor shall be used.
_ WARNING! Don't use the rain cover (if present)
on a product without a hood or parasol that can
hold it. Always use the rain cover only under adult
supervision. Don't use the rain cover indoors and
check to ensure the child is not to warm; do not
park the vehicle close to heat sources and keep well
away from the lighted cigarettes. Ensure that the rain
cover is not interfering with any moving parts of the
carriage/stroller. Always remove the rain cover before
folding your carriage/stroller.
_ WARNING! This product is not suitable for running or
skating.
_ Always apply the brake when loading or unloading
children.
_ WARNING! Do not add any mattress are not
approved by the manufacturer.
_ Do not use accessories which are not approved by
the manufacturer.
COMPONENTS OF THE ITEM
Check the contents of the packaging and if you have
any complaints please contact the Assistance Service.
_ Duette Piroet chassis: 2 rear wheels, 2 front wheels.
INSTRUCTIONS
1 FITTING THE WHEELS: With the chassis closed, fit the
front wheels by inserting them until they click (fig_a)
and then proceed similarly with the rear wheels until
they click (fig_b).
2 OPENING: activate the brake on the folded chassis.
Raise the handlebar in the direction of the arrow
(fig_a) and lock it until the final click (fig_b).
3 BRAKE: to activate the brake on the chassis, push down
with your foot on the brake bar located on the rear
wheels, as shown by the arrows in the figure.
4 Check that the opening is correct, as in the figure.
5 BASKET: Insert the support tube into the fabric loop
on the back of the basket, with the two silver buttons
facing downward (fig_a). Press the silver buttons under
the metallic tube and slide it into its seats on the back
of the chassis (fig_b).
6 IMPORTANT! Fix the three lower eyelets of the basket
to the three grey buttons located above the rear bar.
Please note that the eyelets open (fig_a).
Fix the two upper eyelets of the basket to the two
grey buttons on the sides of the basket tube supports.
Please note that the eyelets open (fig_b).
7 Fix the two upper eyelets of the basket to the two grey
buttons on the front supports of the basket (fig_c). Run
the two zip strips, upper and lower, respectively over
and under the front chassis tubes (fig_d).
8 Join the zip strips together and pull the zip shut (fig_e).
9 Fix the four side Velcro strips to the basket tubes, as
shown in the figure.
10 SWIVEL WHEELS Lower the lever to lock the front
wheels (fig_a). Move the lever in the opposite direction
to make the wheels swivel (fig_b). The rear wheels are
fixed.
11 SIDE HANDLES: the complete chassis may be lifted
using the central external handles (fig_a) and the rear
handlebar (fig_b). The chassis must be lifted by two
people.
Figure C shows the correct way to lift it.
12 WHEEL REMOVAL: To remove the rear wheels: pull the
pivot outwards and remove the wheel as shown in the
figure (fig_a).
To remove the front wheels: press the tab as shown
and remove the wheel (fig_b).
13 FOLDING: apply the brake and release the seats.
To close the chassis, push the side button, lift both
levers on the handlebar (fig_a) and rotate it forward
(fig_b) until it closes (fig_c).
You can fold up the frame without releasing the Pop-
Up seats. To do this, lower the backrest of both seats
fully forward.
- 12 -