Tape Operation - Panasonic PV-DF2700-K Service Manual

Tape Operation

Commercial Skip
By pressing the CM SKIP button in Play mode, you can skip
over 1 to 3 minutes of recorded tape in just a few seconds.
1
Program End Search
Each time a recording is made, an invisible index mark is
placed on the tape. This allows you to easily search for the
end of your recordings to continue or start a new recording.
a
b
SELECT SEARCH MODE
ZERO SEARCH
I NDEX SEARCH
PROGR OGRAM END END SEA EARCH RCH
SELECT :
SET : SET
END : SEARCH
Example of Program End Search operation.
Fig.1
Program 1
Press SEARCH button
FF
Fig.2
Program 1
Press SEARCH button
Fig.3
If search exceeds a few seconds in BLANK area.
Press SEARCH button
Program 1
End Point
If Program End Point is found.
The search continues slightly beyond the end point, then search and reverse
search and plays the last few seconds of the program and finally stop.
Press SEARCH button
Notes
• If Program End Search is started very close to an index mark, one
program may be skipped over.
• If you want to cancel Program End Search, Press PLAY or STOP.
44
Set Skip Time.
Press CM SKIP* repeatedly
to select skip time as follows.
Display SELECT
SEARCH MODE in
Playback or Stop mode.
Press SEARCH on the remote.
Display PROGRAM END
SEARCH.
1) Press
to select.
2) Press SET
to start search.
PLAYBACK DIRECTION
Program 2 or BLANK
End Point
Program 2
BLANK
FF
BLANK
FF
Your unit is equipped with several time
saving features as well as convenient
automatic functions which make tape
operation easier than ever.
Repeat Play
BLANK
Set to see a recording over and over.
End Point
PLAY
REPEAT ON
Program 2
To turn "ON,"
press PLAY/REPEAT on the unit
repeatedly in Play mode to select
"REPEAT ON".
To turn "OFF,"
repeat above to select "REPEAT OFF."
• Playback repeats when tape end is
reached or unrecorded portion over 30
seconds is detected.
Note
• For repeat play in DVD mode, see
page 59.