Specification:
0.1 mm ~ 0.13 mm
1. Remove the VCR Chassis Unit and then place it upside down.
2. Remove the Main C.B.A.
3. Slightly loosen Screw (A). Then set the Screwdriver (Phillips Driver) into the Hole
(A). Turn the screwdriver clockwise until the MR Head touches the rotor. Then
turn it slightly counterclockwise to make the clearance as specified.
4. Tighten Screw (A).
5. Reinstall the Main C.B.A.
Fig. M3-1
111