BMW Wallbox Instructions For Use Manual page 46

Do not pull the vehicle connector plug by the cable, and instead use the handle on the
vehicle connector plug to remove it from the vehicle socket.
Ensure that the vehicle connector plug is not mechanically damaged (kinked, jammed, or
run over) and that the contact area does not come into contact with heat sources, dirt or
water.
Do not touch the contacts on the vehicle connector plug.
Always carry out an inspection for signs of damage before the charging cycle. Pay
particular attention to dirt and moisture on the vehicle connector plug, cuts in the cable or
chafing areas on the insulation. Ensure that the cable output is firmly secured to the BMW
Wallbox.
Do not clean the BMW Wallbox with a water jet (hosepipe, pressure washer, etc.).
Ensure that the BMW Wallbox is not damaged by being handled incorrectly.
Do not open the cover on the terminal block if the BMW Wallbox is installed outdoors and it
is raining or snowing.
Danger of breaking the plastic housing (protection class IK09).
Do not use countersunk screws to secure the device.
Only tighten the screws to the specified torque.
The installation surface must be completely level (max. 1 mm difference between the
support and fastening points). Do not bend the housing
Information for trained personnel who may open the housing: Danger of damage. Electronic
components may be destroyed if touched. Conduct an electrical discharge procedure before handling
modules by touching a metallic, earthed object. If you fail to follow the safety information, there is a risk
of death, injury and damage to the device. The manufacturer cannot accept any liability for resultant
claims.
1.3 CE declaration of conformity
The CE declaration of conformity can be downloaded from the following link.
https://www.bmw.com/supportwallboxgen3
1.4 Declaration of conformity for electromagnetic compatibility: Federal
Communications Commission Part 15
The BMW Wallbox complies with all the specifications from Part 15 of the Federal Communications
Commission. Operating the BMW Wallbox is subject to the following conditions: (1) This device must
not cause any harmful interference, and (2) This device must accept all received interference, including
interference which may cause it to malfunction.
45