Installing A Pim - Cisco Catalyst IR1800 Rugged Series Hardware Installation Manual

Installing a PIM

Installing a PIM
The modular cellular modem pluggable module's Remove and Replace options follow.
The IR1800 may have a blank plate covering the pluggable module slot. If it exists, remove it prior to installing
the cellular modem module. The following steps show the LTE pluggable module, however, they apply to
other modules as well.
Procedure
Step 1 Remove the blank plate by unscrewing the latch lock screw(1) that holds the plate secure. Refer to the following
graphic.
Figure 12: Latch Lock Screw
1
Step 2 Slide the blank plate out of the device.
Step 3
Prepare the cellular modem module by inserting the micro sims that are applicable for your modems into the
device. Remove the screw (1) holding the access plate which covers the SIM slots. The access plate is located
on the side of the module, as shown in the following figures.
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
44
Pluggable Interface Modules
Latch lock screw