This Device Meets Fcc Guidelines For Exposure To Radio Waves; Fcc Radiation Exposure Statement - Cisco Catalyst IR1800 Rugged Series Hardware Installation Manual

Regulatory Compliance
As such the systems are designed to be operated as to avoid contact with the antennas by the end user. We
recommended that you set the system in a location where the antennas can remain at least at a minimum
distance, as specified, from a user in accordance with the regulatory guidelines that are designed to reduce
the overall exposure to a user or operator.
The World Health Organization has stated that present scientific information does not indicate the need for
any special precautions for the use of wireless devices. They recommend that if you are interested in further
reducing your exposure, then you can easily do so by reorienting antennas away from users, or by placing he
antennas at a greater distance than recommended.

This Device Meets FCC Guidelines for Exposure to Radio Waves

The IR1800 Series device includes a radio transmitter and receiver. It is designed to not exceed the limits for
exposure to radio waves (radio frequency electromagnetic fields) as referenced in FCC Part 1.1310. The
guidelines are based on IEEE ANSI C 95.1 and include a substantial safety margin designed to ensure the
safety of all persons, regardless of age and health.
As such the systems are designed to be operated so as to avoid contact with the antennas by the end user. We
recommend that you set the system in a location where the antennas can remain at least at a minimum distance,
as specified, from a user in accordance with the regulatory guidelines that are designed to reduce the overall
exposure to a user or operator.
The device has been tested and found compliant with the applicable regulations as part of the radio certification
process.
The U.S. Food and Drug Administration has stated that present scientific information does not indicate the
need for any special precautions for the use of wireless devices. The FCC recommends that if you are interested
in further reducing your exposure, you can easily do so by reorienting antennas away from users, or by placing
the antennas at a greater distance than recommended, or by lowering the transmitter power output.
Note
As per FCC ECFR 2.1091 and 2.1093 exempt criteria, single transmissions are exempted from the RF Exposure
calculation. The calculation consideres 100 percent of the duty cycle for all simultaneous transmission
technology. The RF Exposure Calculation is done without compensating cable and connector losses. The RF
Exposure calculation is performed with the highest supported antenna gain.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 30cm between the radiator and your body.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
This Device Meets FCC Guidelines for Exposure to Radio Waves
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
97