Gateway 960 User Manual page 103

Invalid partition table
■
The master boot record may be corrupt. For troubleshooting information,
see "The master boot record is corrupted" on page
Invalid password
■
Enter your password again. Some passwords are case sensitive.
■
If you do not know the password, you may need to reinstall the software
you are trying to access.
■ Startup passwords are stored in BIOS. If this password has been set and
you do not know it, you may be able to reset the password through system
board jumper settings. For more information, see
passwords" on page
Keyboard not detected
■ See "The keyboard does not work" on page 108
■ Turn off the server, then check the keyboard cable.
Keyboard stuck key failure
■
Remove any objects that may be resting on the keyboard, then restart the
server.
■ Make sure that a key is not stuck. Clean the keyboard if necessary.
Memory errors were detected while the system started up
■ See "Memory errors were detected during server start up" on page 109
a possible solution.
Memory size error
■ Open the BIOS Setup utility, then save the memory configuration.
Missing operating system
■ The master boot record may be corrupt. For troubleshooting information,
see "The master boot record is corrupted" on page
■ Use FDISK to make sure that your hard drive has an active partition. On
FDISK's main menu, select the Set Active Partition option. In MS-DOS or
Windows 95, the only partition that can be set as active is the primary DOS
partition.
91.
www.gateway.com
Error messages
106.
"Resetting BIOS
for a possible solution.
106.
for
97