For Control Unit Rcu-014 - Furuno FAR-2157 Installation Manual

6. For Control Unit RCU-014:

a) While pressing and holding down the [HL OFF] key, press the [MENU] key five times.
b) Press the [0] key to show the INITIALIZE menu.
For Control Unit RCU-015:
See the procedure on the next page for how to show the INITIALIZE menu.
7. RCU-014: Press the [2] key to open the ECHO ADJ menu.
RCU-015: Choose 2 ECHO ADJ and then push the thumbwheel.
8. RCU-014: Press the [3] key to choose HD ALIGN.
RCU-015: Choose 3 HD ALIGN and then push the thumbwheel.
9. RCU-014: Key in the bearing difference. The setting range is 0 to 359.9(°).
RCU-015: Spin the thumbwheel to set the bearing difference and then push the thumbwheel.
The setting range is 0 to 359.9(°).
10.Confirm that the target echo is displayed at correct bearing on the screen and then push the
thumbwheel.
11.RCU-014: Press the [MENU] key to finish.
RCU-015: Left-click the MENU box to finish.
[INITIALIZE]
1 BACK
2 [ECHO ADJ]
3 [SCANNER]
4 [INSTALLATION]
5 [OWN SHIP INFO]
6 [ARP PRESET]
7 [NETWORK]
8 [OTHER]
INITIALIZE menu
[ECHO ADJ]
1 BACK
2 CABLE ATT ADJ
AUTO/MANUAL
30
3 HD ALIGN
000.0
4 TIMING ADJ
0
5 MBS
0
6 DEFAULT ANT HEIGHT
5/7.5/10/15/20/
25/30/35/40/45/
more 50 m
7 NEAR STC CURVE
2/2.5/3/3.5/4.2
8 MID STC CURVE
3/4/5/6
9 FAR STC CURVE
6/7/8
0 RING SUPPRESSION
0
ECHO ADJ menu
3-3