Furuno MARINE RADAR 1823C Installation Manual page 28

6. Unfasten four screws shown in the figure below.
7. Pass the signal cable through the cable protector.
8. Connect the signal cable to the RTB Board (03P9249), referring to the interconnection
diagram and the figure below.
9. Attach three EMI cores to the signal cable as shown below.
1-18
Tubing
Within 4 cm
Plate
Flat
washer
CABLE GLAND
How to fix signal cable in cable gland
Antenna unit chassis, cover opened
Antenna unit chassis, cover opened
Shield
Sheath
Bolt
Gasket