Table of Contents
Advertisement
3.2 Leg and Caster Installation (cont.)
3.
Rigid casters must be installed on the fryer rear-channel assembly only.
4.
Proceed to Step 3.3, Leveling the Fryer, after legs and rear rigid casters are installed to
ensure the fryer is level before using.
B. Leg and Rigid Caster Installation
1. Remove unit from pallet.
2. Carefully raise unit with forklift, pallet jack, or other steady means.
3. Place one lock washer on each hex head screw.
4.
Insert hex head screws with lock washers [1/4-20 threads by ¾" (19 mm) long] through bolt
holes of leg mounting plates and mount to the front channel. Mount rigid casters to the rear
channel following the same procedure. A locknut has been attached to the topside of the
base mounting plates at the factory to capture the hex head screw as it is screwed in.
5.
Tighten the bolts to 50 inch-lbs. (5.65 Nm) torque.
3.3 Leveling the Fryer
A. Place a carpenter's level across the top of the fryer and level the unit front to back. If the fryer is
not level from side to side, a platform or other surface adjustment is needed; there is no side-to-
side level adjustment on a fryer equipped with caster/leg combinations. (If a fryer is equipped
with legs only, side-to-side level adjustments can be made. If a fryer is equipped with casters
only, no level adjustments can be made.). If the fryer is not level, the unit may not function
efficiently, the oil may not drain properly for filtering and in a multi-fryer battery, it may not
match adjacent units.
Legs (Only)
1.
Adjust leg height with an adjustable or 1-1/16-inch (27 mm) open-end wrench by turning
the hex bullet on the bottom of the leg.
2. The hex bullet is for minor leg height adjustment only. Do not adjust more than 1-inch
(25.4 mm).
3. When leveling the unit, the leg body should be held firmly to keep the leg from bending or
rotating while turning the hex bullet foot to the required height.
SUPER MARATHON SERIES GAS FRYERS
CHAPTER 3: INSTALLATION INSTRUCTIONS
3-2
Advertisement
Table of Contents
