Battery Priority Setting [Active Battery]; Battery Priority Setting - Fostex PD606 Owner's Manual

Using the "Active battery" item, you can select the prior battery (BATT1 or BATT2) when you
set batteries to both the BATT1 and BATT2.
See "Battery setting examples" on pages 176 and 177 for the examples of battery priority set-
ting. The setting you make using this item is reflected to the "POWER" area on the display.
You can also make the prior battery setting via the quick setup mode (see page 77).
<Note>: If the voltage of the prior battery drops down to the threshold voltage set via the
"BATT warning" item, the unit change the active battery to the other one in the manner
described below. Note that when the unit changes the active battery, the setting of the
"Active battery" item also changes.
• BMS battery: If the time until the battery voltage drops down to the threshold voltage set via the "BATT
warning" item becomes less than one minute, the active battery changes automatically.
• Non BMS battery: If the battery drops down to the threshold voltage set via the "BATT warning" item, the
display shows the "warning" message and the active battery changes automatically.
Note that even if you replace the prior battery with a new one, the active battery does not change.
If you want to make the replaced battery active, you must make setting of the "Active battery" item again.
1) While the unit is stopped, press the [SHIFT] key followed by the [ENTER/YES] key.
2) Use the [MENU] dial to select the "BATTERY SETUP" menu and press the [ENTER/YES] key.
The display shows the screen for battery-related settings.
3) Use the [MENU] dial to select the "Active battery" menu item and press the [ENTER/YES] key.
The current setting starts flashing. You can now select the prior battery.
You cannot select an option whose battery power voltage is lower than the
<Note>:
threshold voltage.
If a battery is set to either of "BATT1" or "BATT2", or if no battery is set, you
<Note>:
cannot make selection of this item.
4) Use the [MENU] dial to select a desired option and press the [ENTER/YES] key to confirm
your setting.
5) Press the [EXIT] key repeatedly until you exit the MENU mode.

Battery priority setting [Active battery]

"BATT1" and "BATT2" (the default is "BATT1".)
Chapter 8: MENU mode/BATTERY SETUP menu
Available options
Location Recorder Model PD606
Flashing
175