Quick Start - CVEQ/SVEQ 100 Series, cont'd
When using long cables, follow these steps:
a.
Supply the color bars test signal to the input. (Recommendation:
use an Extron VTG 300 Video Test Generator to generate the test
signal.)
b.
Adjust the Gain control(s) for the output until the signal level
at the far end is the same as the input (or the display shows the
correct brightness and contrast).
c.
Adjust the EQ control for the output so that no overshoot or
round front corner appears at the far end on the oscilloscope or
you see a sharp picture with no smearing.
Step 7
See "Installation Instructions" in chapter 2 for further installation
details.
QS-2
CVEQ 100 and SVEQ 100 Series • Quick Start Guide
Table of Contents
.................................................................... 1-2
........................................................................................ 1-2
Chapter Two • Installation
............................................................... 2-2
Tabletop use ............................................................................2-4
Rack mounting ........................................................................2-5
............................................................................... 3-13
CVEQ 100 and SVEQ 100 Series • Table of Contents
................................................... 1-1
..................................................... 2-1
........................................................... 2-4
..................................................... 3-1
................................... 3-2
..................................... 3-6
TOC-i