Table of Contents
Advertisement
Figure 3-4 — Setting the IP address in Global Configurator
Setting the IP address using embedded Web pages
Each IPL T S unit contains an on-board Web server with interactive pages that can
be used to configure the device.
The IPL T S unit must be at its factory default IP address.
To set an IP address via embedded Web pages:
1.
Connect an Ethernet crossover cable between the device and a local PC.
2.
On the PC, locate the TCP/IP Properties dialog box.
On Windows
Start > My Network Places > right-click to Properties > Local Area Connection
> right-click to Properties > Internet Protocol (TCP/IP) > Properties.
3.
Record the current IP address, subnet mask, default gateway and DHCP
settings. You will need this information later to return the PC to its original
TCP/IP settings.
IP Address:
.
Subnet Mask:
.
4.
Enter the following:
IP address: 192.168.254.253
Subnet mask: 255.255.0.0
Default gateway: <blank>
XP, the TCP/IP Properties dialog box is found at:
®
.
.
.
.
IPL T S Series • Connection and Configuration
3-5
Advertisement
Table of Contents
