Ul Guidelines For Rack Mounting - Extron electronics IPL T S Series User Manual

Installation and Operation
Installation Overview
To install and set up an IPL T S interface, follow these steps:
1.
2.
3.
4.
5.
Mounting the IPL T S Interface

UL guidelines for rack mounting

The following Underwriters Laboratories (UL) guidelines pertain to the installation
of an IPL T S Series unit onto a rack.
1.
2.
3.
4.
5.
2-2 IPL T S Series • Installation and Operation
Turn all of the equipment off. Make sure that the video sources (DSS, cable
boxes, or other devices), the IPL T S unit, the output devices (monitors, VCRs,
projectors, etc.) and the serial controller are all turned off and disconnected
from the power source.
Mount the IPL T S interface. See "Mounting the IPL T S Interface", below.
Attach the cables. See "Connecting the Hardware" in chapter 3.
Connect power cords and turn on the devices in the following order: output
devices (projectors, monitors, speakers), IPL T S interface, serial controller or
computer (PC), then input devices (DSS, cable boxes, etc.).
Configure the IPL T S interface through DataViewer or Telnet, then access the
unit using an Internet browser.
Elevated operating ambient — If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment may be
greater than room ambient. Therefore, consider installing the equipment in an
environment compatible with the maximum ambient temperature specified
by the manufacturer [Tma =
Reduced air flow — Installation of the equipment in a rack should be such
that the amount of air flow required for safe operation of the equipment is not
compromised.
Mechanical loading — Mounting of the equipment in the rack should be such
that a hazardous condition is not achieved due to uneven mechanical loading.
Circuit overloading — Consideration should be given to the connection of the
equipment to the supply circuit and the effect that overloading of the circuits
might have on overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be used when
addressing this concern.
Reliable earthing (grounding) — Reliable earthing of rack-mounted
equipment should be maintained. Particular attention should be given to
supply connections other than direct connections to the branch circuit (such as
the use of power strips).
+32 to +122 °F (0 to +50 °C)].