Furniture Or Projector Mounting - Extron electronics IPL T S Series User Manual

Installation and Operation, cont'd
Figure 2-2 — Mounting the interface on the standard shelf

Furniture or projector mounting

The following furniture and projector mount kits are available:
•
•
•
•
To mount an IPL T S Series device to furniture:
1.
2.
3.
4.
5.
6.
To mount an IPL T S Series device with a projector:
1.
2.
3.
2-4 IPL T S Series • Installation and Operation
IP L
T S
2
R
C O
M
1
2
®
1 0
0
IP L
L IN
T S
K 2
A C
T
R
C O
M
1
2
®
1 0
0
L IN
K
A C
T
PN 70-077-01 Furniture mount kit (for IPL T S1)
PN 70-077-04 Projector mount kit (for IPL T S1)
PN 70-212-01 Furniture mount kit (for IPL T S2, S4, S6)
PN 70-217-04 Projector mount kit (for IPL T S2, S4, S6)
If present, remove the rubber feet from the bottom of the IPL T S unit.
Attach the furniture mounting brackets to the unit with the supplied screws.
Hold the unit with the attached brackets against the underside of the
furniture. Mark the hole locations of the bracket on the mounting surface.
Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the underside
of the mounting surface at the marked hole locations.
Insert #8 wood screws into the four pilot holes. Tighten each screw until just
less than 1/4" (6.3 mm) of the screw head protrudes above the surface.
Hang the mounting bracket over the protruding screw heads. Slide the
mounting brackets to the narrow end of the screw slots and tighten the
mounting screws.
If present, remove the rubber feet from the bottom of the IPL T S unit.
Attach the projector mounting bracket to the unit with the supplied screws.
Secure the unit to the projector post with the supplied mounting bolt.