Power - Extron electronics IPL T S Series User Manual

Installation and Operation, cont'd
Figure 2-7 — IPL T S6 interface back panel

Power

a
C
Smooth
A
Figure 2-8 — Power connector wiring
N Do not tin the stripped power supply leads before installing the captive screw
C
To verify the polarity before connection, plug in the power supply with no load and
check the output with a voltmeter.
2-6 2-6 IPL T S Series • Installation and Operation IPL T S Series • Installation
10
00-05-A6-00-00-06
LAN
POWER
12V
COM3 COM4 COM5 COM6
.5A MAX
TX RX TX RX TX RX TX RX
1 2 3 4 5
Power connection — Plug the unit's external 12 VDC power supply into this
connector. The power supply is provided with the unit.
When you are connecting the power supply, voltage polarity is extremely
important. Applying power with incorrect voltage polarity could damage
the power supply and the interface. Identify the power cord negative lead by
the ridges on the side of the cord.
Ridges
A
SECTION A–A
Power Supply
Output Cord
Orange Captive
Screw Connector
Ground
+12 VDC
Power Supply
Output Cord
connector. Tinned wires are not as secure in the captive screw connectors and
could pull out.
The two power cord wires must be kept separate while the power supply is
plugged in. Remove power before continuing.
6
COM1
COM2
7
3/16"
(5 mm) Max.
External
Power Supply
(12 VDC, 1 A )
AC Power Cord