Setting The Internet Protocol (Ip) Address - Extron electronics IPL T S Series User Manual

Lighting
Control
# 09
U ID
W E
P O
V M A
12
.5 A
Ethernet
Remote User
Control and
Administrator
Monitoring
Figure 3-2 — Typical IPL T S interface operating configuration
2. Connect the other end of the serial cable to the display or switching device to
be controlled through the IPL T S.

Setting the Internet Protocol (IP) Address

The IPL T S Series units have a factory default IP address of 192.168.254.254. This
IP address must be changed to an address that will operate on your local network.
There are three ways to change the IP address setting:
• Add Device > Auto Config IP option in Global Configurator
• IPL T S unit's embedded Web pages
• Address Resolution Protocol (ARP) command
Before you begin:
1. Obtain a valid IP address for your IPL T S Series device from your A/V
system's network administrator.
2. Write down the unit's MAC address (a 12-digit number) found on a label on
the rear panel of the unit (ex: 00-05-A6-01-0A-74).
3. If the unit is not at it's factory default IP address (192.168.254.254), perform a
Mode 4 reset:
a.
b.
RS-232
Extron
IPL T S4
Ethernet Control
3
M
C O
Interface
2
1 M
M C O
C O
2
2 M
05 C O
12
30
L A N
RS-232
R
X
V C R
AY
DIS PL WE R
PO
LU ME
VO
TCP/IP
/
MAX
MIN
Network
RS-232
n
tr o
E x
Extron
MediaLink or
Other Controller
Projector
Laptop DVD
VCR
Hold down the Reset button until the Power LED blinks twice (6
seconds), then release.
Press and release the Reset button again within 1 second.
The Power LED blinks quickly four times, confirming the Mode 4 reset,
which returns the unit to its factory default IP address.
IPL T S Series • Connection and Configuration
Extron
MAV 62
Matrix Switcher
pt op
La
D
D V
6
C 20 r
ML ntr olle
k Co
dia Lin
Me
3-3