How To Operate; Floor/Carpet Cleaning; Power Edge Cleaning; Above Floor Cleaning - Dirt Devil Swivel Glide Owner's Manual

1.

CARPET SETTINGS

NOTE: The cleaner may be in the upright or operating position to adjust carpet setting.
1. Adjusting in the upright position: Rotate the knob to the desired setting.
(Diagram 1).Once the carpet setting is selected, and the cleaner placed in the operating position, the setting will be in the c
2. Adjusting in the operating position: Rotate the knob to the desired setting.
nozzle will raise and lower as the knob is rotated.

HOW TO OPERATE

1. Plug cord into electrical outlet.
2. Turn cleaner "on". Power pedal located on left side of back of unit (Diagram 2).
3. With foot, depress the handle release pedal on the right side of the cleaning nozzle (Diagram 3).
NOTE: Rotating brush could cause area rug fringe to become tangled within cleaner. Use caution when vacuuming throw rugs
with fringe.
*FOR POWER EDGE CLEANING: Remove Power Edger
™
Remove hose end from side of unit and hose caddy. Slide hose end onto Power Edger
superior edge cleaning (Diagram 4).
1.

ABOVE FLOOR CLEANING

Cleaner must be in the upright position to lift the rotating brush off the carpet when cleaning above the floor.
1. Put cleaner in its upright position.
2. Remove the hose from the side of the cleaner using the handle (Diagram 1).
3. Choose any of the handy accessories or use the hose alone. Simply push the attachment firmly onto the end of the wand or hose
handle. To remove tool, twist and pull apart gently.
*4. If additional length is needed use the Extension wand.
*STRETCH HOSE ® AND HOSE ANCHOR:
floor cleaning attachments.
2) and secure hose anchor ring (Diagram 3a) located around hose to base. Pull hose from hose handle for additional length (Diag
EXTENSION WAND:
*Not available on all models
2.
2.
The Hose Anchor is used to prevent the vacuum from tipping while using the above
Remove the hose from the side of the cleaner using the handle.
Remove wand from side of cleaner by pulling out at the top to unsnap and pull up (Diagram 4).
3.
NOTE: The knob will rotate easily. Your setting is working
NOTE: The knob will rotate with some resistance. The
from lower back panel. Insert Power Edger
™
™
3a.
6
4.
into desired Power Edger
™
. Glide the upright against walls and baseboards for
4.
3b.
Lay hose over the back of the cleaner (Diagram
orrect position.
slot.
™
ram 3b).