Table of Contents
Advertisement
CaUTiOn
Don't over saturate your carpet.
OPERATE THE CARPET WASHER
1. Plug into a mains. Turn the power and
brushbar switches on. The switches are
located on the front of the carpet washer,
above the clean water tank. The power
switch controls the motor and pump,
the brush switch only turns the rotating
brushbar on and off when the power
switch is on.
3. While pressing the solution release
trigger, push the cleaner in a forward
motion. Release the trigger and pull
the cleaner backwards over the same
path to remove the dirty water and
solution from the carpet. Repeat if
necessary.
CaUTiOn
To reduce the risk of fi re and electric shock due
to internal component damage, use only Dirt
Devil brand cleaning solution intended for use
with this appliance.
2. Press on the handle release pedal
and pull the cleaner back into a
reclined position.
11
Advertisement
Table of Contents
