Troubleshooting - Yamaha CRUX REV YD110-1 2016 Owner's Manual

Periodic maintenance and adjustment
and then install the brake pedal
free play adjusting nut onto the
brake rod.
5. Connect the brake torque rod to
the brake shoe plate by installing
the bolt, washer and nut.
6. Adjust the drive chain slack. (See
page 7-21.)
7. Tighten the axle nut, and then the
brake torque rod nut to the speci-
fied torques.
Tightening torques:
Axle nut:
75 N·m (7.5 kgf·m, 54 lb·ft)
Brake torque rod nut:
7
19 N·m (1.9 kgf·m, 13 lb·ft)
8. Insert a new cotter pin into the
brake torque rod bolt, and then
bend the ends of each cotter pin.
WARNING! Always use new cot-
ter pins.
[EWAE0011]
9. Install the drive chain case by se-
cured the drive chain case lock
and installing the collars and bolts.
10. Tighten the drive chain case bolts
to the specified torque.
Tightening torque:
Drive chain case bolt:
7.0 N·m (0.7 kgf·m, 5.1 lb·ft)
11. Adjust the brake pedal free play.
(See page 7-20.)
WARNING
After adjusting the brake pedal free
play, check the operation of the
brake light.
7-37

Troubleshooting

Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
EWA10661
for example, can cause poor starting
and loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
WARNING
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the ar-
ea, including pilot lights from water
EAU25852
EWA15142