Cleaning And Lubricating The Drive Chain - Yamaha CRUX REV YD110-1 2016 Owner's Manual

Periodic maintenance and adjustment
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both washer edges are in the same po-
sition for proper wheel alignment.
1
ZAUE2604
7
1. Washer
2. Alignment marks
5. Tighten the locknuts, and then
tighten the axle nut to the speci-
fied torques.
Tightening torques:
Drive chain puller locknut:
16 N·m (1.6 kgf·m, 12 lb·ft)
Axle nut:
75 N·m (7.5 kgf·m, 54 lb·ft)
6. Adjust the brake pedal free play.
(See page 7-20.)
WARNING
After adjusting the brake pedal free
play, check the operation of the
brake light.
7. Make sure that the drive chain
pullers are in the same position,
the drive chain slack is correct,
and the
2
smoothly.
EWA10661
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart. Otherwise it will quickly
wear out, especially when riding in
dusty or wet areas. Service the drive
drive chain moves
chain as follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
TIP
7-23
1. Clean the drive chain with kero-
sene and a small soft brush.
2. Rinse off any remaining dirt and
then wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with clean engine oil.
4. Wait a few minutes to let the oil
soak in, and then wipe off any ex-
cess.
If kerosene or other high flash-
point solvent is not available, soap
and water may also be used.
EAUE2350
ECA10584