Yamaha CRUX REV YD110-1 2016 Owner's Manual page 69

1. Brake camshaft lever
2. Drive chain puller locknut
3. Drive chain slack adjusting bolt
4. Axle nut and washer
5. Brake rod
6. Washer
7. Spring
8. Brake pedal free play adjusting nut
6. Loosen the drive chain puller lock-
nut and the drive chain slack ad-
justing bolt on both ends of the
swingarm.
7. Remove the axle nut and washer,
and then pull the wheel axle and
collars out.
Periodic maintenance and adjustment
ZAUE2629
1. Wheel axle
2. Collar
TIP
A rubber mallet may be useful to tap
the wheel axle out.
8. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
7-36
2
ZAUE2630
1. Drive chain
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
9. Remove the wheel.
To install the rear wheel
1. Install the drive chain onto the rear
sprocket.
2. Install the wheel by inserting the
collars and wheel axle from the left
side.
3. Install the washer and the axle nut.
4. Install the washer and spring onto
the brake rod, connect the brake
rod to the brake camshaft lever,
1
7